Operation - DeWalt D25601-XE Instruction Manual

– when breaking or drilling in harder materials, set the dial to a high setting.
FIG. 3
G
S
T
Depth Rod (Fig. 1)
TO ADJUST THE DEPTH ROD
1. Push in and hold the depth rod release
button (N) on the side handle.
2. Move the depth rod (O) so the distance
between the end of the rod and the end of
the bit equals the desired drilling depth.
3. Release the button to lock rod into
position. When drilling with the depth rod,
stop when end of rod reaches surface of
material.
Indexing the Chisel Position
(Fig. 5)
The chisel can be indexed and locked into 18
different positions.
FIG. 4A
FIG. 4B
M
FIG. 5
F
7
1. Rotate the mode selector switch (F) until it points towards the
2. Rotate the chisel in the desired position.
3. Set the mode selector switch (F) to the "hammering only" position.
4. Twist the chisel until it locks in position.

OPERATION

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
WARNING: To reduce the risk of personal injury, ALWAYS ensure workpiece is
anchored or clamped firmly. If drilling thin material, use a wood "back-up" block to
prevent damage to the material.
WARNING: To reduce the risk of personal injury, ALWAYS operate the tool with
the side handle properly installed and securely tightened. Failure to do so may
result in the side handle slipping during tool operation and subsequent loss of control.
Hold tool with both hands to maximize control.
WARNING: The use of a residual current device (RCD) protected supply with a
rated residual current of 30 mA or less is recommended. The use of a RCD reduces
the risk of electric shock.
Trigger Switch (Fig. 1)
To turn the tool on, depress the trigger switch (A).
To stop the tool, release the trigger switch.
The lock-on slider (B) allows the trigger switch (A) to be locked on in chiselling mode
only. If the lock-on button is activated in drilling mode, as a feature the tool will switch
off automatically.
To turn the tool on, press the trigger switch (A).
To stop the tool, release the switch.
For continuous operation, press and hold down the switch (A), slide the lock-on
button (B) upwards and release the switch.
To stop the tool in continuous operation, press the switch briefly and release it.
Always switch off the tool when work is finished and before unplugging.
position.