Makita 6916D Instruction Manual page 10

This tool has a reversing switch to change
the direction of rotation. Depress the re-
versing switch lever from the A side for
clockwise rotation or from the B side for
counterclockwise rotation. When the switch
lever is in the neutral position, the switch
trigger cannot be pulled.
R e v 7 i n g y i l c h :
Clockwise Counterclockwise
ASSEMBLY
Installing or removing driver bit or drill bit
CAUTIO N
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Use only the driver bit or socket bit shown
in the figure.
Do
not use any other driver bit
or socket bit.
To install the bit, pull the sleeve in the
direction of the arrow and insert the bit into
the sleeve as far as
it
will go. Then release
the sleeve
to
secure the bit. To remove the
bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
T
Bit Sleeve
NOTE:
If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its
original position and the bit will not be secured. In this case, try re-inserting the bit accord-
ing to the instructions above.
10