Bosch AXT Rapid 2000 Original Instructions Manual

Bosch AXT Rapid 2000 Original Instructions Manual

Hide thumbs Also See for AXT Rapid 2000:

Advertisement

OBJ_DOKU-24769-001.fm Page 1 Wednesday, December 1, 2010 9:06 AM
Robert Bosch GmbH
Power Tools Division
70745 Leinfelden-Echterdingen
Germany
www.bosch-garden.com
F 016 L70 460 (2010.12) O / 12 XXX
AXT RAPID
2000 | 2200
en Original instructions

Advertisement

Table of Contents
loading

Summary of Contents for Bosch AXT Rapid 2000

  • Page 1 OBJ_DOKU-24769-001.fm Page 1 Wednesday, December 1, 2010 9:06 AM Robert Bosch GmbH Power Tools Division 70745 Leinfelden-Echterdingen AXT RAPID Germany www.bosch-garden.com 2000 | 2200 F 016 L70 460 (2010.12) O / 12 XXX en Original instructions...
  • Page 2 F 016 L70 460.book Seite 2 Mittwoch, 1. Dezember 2010 10:01 10 2 • F 016 L70 460 • 10.12...
  • Page 3 F 016 L70 460.book Seite 5 Mittwoch, 1. Dezember 2010 10:01 10 3 • F 016 L70 460 • 10.12...
  • Page 4 F 016 L70 460.book Seite 5 Mittwoch, 1. Dezember 2010 10:01 10 4 • F 016 L70 460 • 10.12...
  • Page 5: Safety Notes

    The operator is responsible for third per- sons in the working area. Bosch can assure flawless functioning of the ma- Before handling the cutter, switch off and re- chine only when original accessories are used. move the plug from the mains supply. If the cable is damaged or cut through while work- Become familiar with the owner’s manual before at-...
  • Page 6: Technical Data

    Do not tamper with the motor speed control settings. – If an extension cord is used it shall not be of Contact a Bosch approved service agent if a prob- lighter grade than the supply cord already fitted to lem exists.
  • Page 7: Intended Use

    If the supply cord is damaged, it must be replaced by switch. It will now move to position “I” (the nor- a Bosch Service Centre. mal run position). Products sold in GB only: Your machine is fitted with...
  • Page 8: Removing Blockage

    Fit the blade, blade washer and the blade bolt. For best results, shred fresh branches soon after Only use a Bosch approved blade bolt. they have been cut. Tighten the bolt firmly (tightening torque 12 Nm).
  • Page 9: Fault Finding

    F 016 L70 460.book Seite 5 Mittwoch, 1. Dezember 2010 10:01 10 Accessories After Shredding/Storage Blade ..........F 016 800 276 Stop and remove plug from the power sup- ply. Collection bag........2 605 411 073 Clean the exterior of the machine thoroughly using a Gloves ..........
  • Page 10 Cutting blade damaged Replace blade Machine damaged internally Contact Service Agent Australia, New Zealand and Pacific Islands Disposal Robert Bosch Australia Pty.Ltd. Power Tools Garden products, accessories and packaging should Locked Bag 66 be sorted for environmental-friendly recycling. Clayton South VIC 3169...
  • Page 11: Noise/Vibration Information

    Typically the A-weighted noise level of the product is: sound pressure level 89 dB(A) (AXT RAPID 2000)/90 dB(A) (AXT RAPID 2200); sound power level 103 dB(A) (AXT RAPID 2000)/ 103 dB(A) (AXT RAPID 2200). Uncertainty K =3 dB (AXT RAPID 2000)/4 dB (AXT RAPID 2200).

This manual is also suitable for:

Axt rapid 2200

Table of Contents