Mitsubishi WD-65000 Owner's Manual page 27

Programming the Remote Control: To Control Other A/V Products
VCR
CABLE/DBS/DTV DVD
TV AUDIO
1
3 DVD/LD Player Codes
DVD/LDP brand Code to enter:
Mitsubishi (DVD) 003
Mitsubishi (LD) 016, 017
Panasonic 250
Pioneer DVD (LD) 252 (, 016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your
DVD/LDP.
VCR
CABLE/DBS/DTV DVD
TV AUDIO
1
3 A/V Receiver Codes
Audio brand Code to enter:
Mitsubishi A/V receiver
Set M-VR1000 or M-VR800 to 015
Set M-VR900 or M-VR700 to 010
Mitsubishi CD player 010, 011
Denon 234, 235, 236
Kenwood 200, 208
JVC 232, 233
Onkyo
209, 214
Pioneer 205, 207
Sony 222
Yamaha 201, 202
To reset to default code, enter 000
Figure 5. Programming the remote to control your
A/V receiver.
If the slide switch is set to TV when
you enter an A/V receiver code, VOL-
UME and MUTE will control the A/V
receiver rather than the TV. To return
volume and mute control to the TV, set
the slide switch to TV, press and hold
POWER and enter 000.
After entering the correct codes in each
POWER
position of the remote control, use the slide
2
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
If your
DVD slide switch is set to TV, the volume and mute
code is not
functions change to match the A/V receiver.
listed here,
please see
This is useful when using an A/V receiver
page 60 for
with the TV all the time. In all other cases,
a complete
listing.
only one of the below devices is allowed for
each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
POWER
VCR position:
VCR
2
DVD position:
DVD
If your
audio
LD Player
code is not
listed here,
please see
Audio position:
page 60 for
A/V receiver
a complete
listing.
Mitsubishi CD player
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A /V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, PLAY, REW, etc.) in the audio position
will operate the CD player.]
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is
the case, your remote control may not
be able to operate your VCR, DVD,
cable box, satellite receiver, or A/V
receiver.
Part III : Setup
[If you have a Mitsubishi A /V
27