Mitsubishi CS-35305 Owner's Manual page 42

Using the remote control to operate cable boxes
and other brands of VCRs (cont.)
_Important:
Important:
_Important:
Sometimes manufacturers will c.hange their products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box.
Each layer (CABLE, VCR-A or VCR-B) can be set for either a cable
box or a VCR.
When you replace the batteries :in your remote control, the remote
may return to its initial setting.
using your remote control to operate your VCR
After you have set up your remote control fb_:your particular brand
of VCR, you can use the remote to operate your VCR.
O Use the select buttons across the top ofth_ remote control to
choose the layer you "set up" to operate the VCR: VCR-A,
VCR-B, or CABLE.
O Point the remote control at the VCR and p:ress the desired
buttons.
If you are using a Mitsubishi VCR, you will be able to use all of the
buttons on the remote control to operate your VCR except fi)r
MUTE, VOLUME and the PIP fhnction buttons, which will always
operate the TV itself.
If you are using another brand of VCR, you c:an use the POWER,
CHANNEL, REC, STOP, PAUSE, REW, PI_,kY and FF buttons to
operate your VCR.
using your remote control to operate your cable box
After you have set up your remote control for your particular brand
of cable box, you can use the remote to operate your cable box.
q[_ Use the select buttons across the top of the remote control to
choose the layer you "set up" to operate the cable box: VCR-A,
VCR-B, or CABLE.
Point the remote control at the cable box a:ad press the desired
buttons.
Only the POWER, CHANNEL, and number _0 - 9) buttons can be
used when operating your cable box.
40 Cha_ter 3: Operating Your TV