Chapter 5 User Preferences; Introduction - Motorola DS3578 Product Reference Manual

Chapter 5 User Preferences

Introduction

This chapter describes each user preference feature and provides the programming bar codes for selecting these
features for the digital scanner.
The digital scanner ships with the settings shown in the
configuration program (see 123Scan2 on page 11-1). on page 5-2
Parameters for all host device and miscellaneous digital scanner defaults). If the default values suit the
requirements, programming is not necessary.
Set feature values by scanning single bar codes or short bar code sequences. The settings are stored in
non-volatile memory and are preserved when the digital scanner powers down.
The digital scanner communicates with the host through the cradle. During digital scanner setup, the digital
scanner is paired with a cradle, which is connected to the host through one of several interfaces (see
page 1-11 and the applicable host interface chapter). Each cradle can pair with up to four digital scanners.
If not using a USB cable, select the host type (see the specific host chapter) after the digital scanner emits
power-up beeps. This is only done upon the first power-up when connecting to a new host.
NOTE Disconnect the power supply before changing host cables or the digital scanner may not recognize the
new host.
To return all features to their default values, scan a
programming bar code menus, default values are indicated with asterisks (
*
*
Indicates Default High Frequency
Configure the digital scanner using the 123Scan2
(also see Appendix A, Standard Default
Default Parameters bar code on
*
).
Feature/Option
Pairing on
page 5-4. Throughout the