Making Tea - Capresso Triple Brew 352 Manual

10. Making Tea

1. Fill water tank as described in chapter 4, Filling the Water Tank.
2. Follow steps above in chapter 6 to fill tea filter with tea leaves or tea bags
and attach filter to brewing unit.
CAUTION: Never use coffee filter or tea filter without provided safety grip!
3. Ensure brewing unit is lined up in correct position when sliding back into
the machine.
4. Remove carafe from machine and replace with drip tray. (Fig F)
NOTE: The machine will not brew TEA when drip tray is not in place.
5. Press TEA button to start brewing.
6. The TEA button will start to flash and will continue to flash during brewing.
7. Once programmed volume has been reached the brewing will automatically
stop and icon on button will stop blinking.
8. To stop brewing at any time, press the flashing TEA button or ON/OFF button.
9. After brewing is complete, brewing unit and filter can be removed from the
machine by pulling the handle of the brewing unit straight out. (Fig. B)
CAUTION: Take care when removing brewing unit and filter from machine
as excess hot water could be stuck inside filter. Wait until all hot water has
passed through the filter before removing the brewing unit.
10. To remove tea filter from brewing unit press locking tab on side of brewing
unit to unlock the filter. (Fig C) Pull filter off of brewing unit and clean as
described in chapter 15, Cleaning & Maintenance.
11. How Much Tea?
We recommend using two level teaspoons (4 grams) of tea leaves per 8 oz. of
water. If you like your tea extremely strong, you can adjust the amount of tea
leaves to your liking up to 8 tablespoons (40 grams).
CAUTION: Never fill the tea filter with tea leaves or tea bags past the 4 ribs on
the inside of the filter.
Light
2 tsp.
1 tea bag
12. Programming Volume
The SMALL, LARGE and TEA button volumes can be reprogrammed to desired
volume as outlined in chapter 5, Control Panel. The CARAFE button cannot be
reprogrammed.
1. Follow steps 1-5 in chapter 7, Making a Single Cup of Coffee.
2. Press and hold the button that will be reprogrammed (SMALL, LARGE or
TEA) for approximately 3 seconds. The icon light will start to blink rapidly
while the beverage is being brewed into the cup.
3. Once the desired volume has been reached in the cup press the flashing
button again and the volume will be reprogrammed for the button.
Light
2 tsp.
1 Tbsp.
5 Tbsp.
9.