Programming The Water Softener - Miele TOUCHTRONIC G 832 SC Operating Instructions Manual

Programming the water softener

If your water is over 8 gr/gal the salt
reservoir must be filled with salt. Your
water hardness level must be
programmed into the dishwasher using
the buttons on the control panel.
^ Make sure the dishwasher is turned
off.
^ Press and hold the "Start/Stop" button
(17) and at the same time turn on the
dishwasher with the "On/Off" button
(13). Release the "Start/Stop" button
within two seconds.
The "Rinse" (16) indicator and the
Pots & Pans indicator (14) will light and
the "Salt" (15) indicator will flash.
If this is not the case, the above steps
must be repeated.
Before using for the first time
1 - 24 gr/gal:
^ Use the program selection buttons
(19) to select the program which
corresponds to the local water
hardness.
Table 1:
gr/gal*
1 - 4**
5 - 7
8 - 11
12 - 16
17 - 21
22 - 24
* US gallons
** factory preset
The selected program indicator (14) will
flash and the "Rinse" (16) indicator will
light.
^ To store this setting press the
"Start/Stop" (17) button twice.
^ Turn off the dishwasher with the
"On/Off" button (13).
ppm Program indicator
Pots & Pans
20 - 70
90 - 130 Sani Wash
140 - 200 Normal Plus
220 - 280 Normal
300 - 370 China & Crystal
390 - 430 Rinse and Hold
15