Table of Contents
Advertisement
Kindly Reminder
The 3D glasses will activate their Auto OFF and Auto run intelligently in the following conditions.
1.
The 3D glasses are standby (for a period of 5 minutes) when powered on, and they will turn into
working mode once received the 3D sync signal during standby mode, otherwise, the glasses will
automatically turn off with the green LED indicator blinking three times.
2.
If the 3D glasses become disconnected with the signal because of : 1> incorrect distance and or
angle, 2> input source changed, 3> switched to 2D mode, they will automatically work for a period
of 3 seconds. The glasses will resume working once a 3D sync signal is received, otherwise, the
glasses will enter into standby mode(for 5 minutes).
Other Information
Specifications
Shutters
Weight
Use range
Transmittance
SYNC Operation
Contrast Ratio
Power supply
Working Currenct
Refreshing rate
Battery working time
Working Condition
Notice: For a better performance of the battery, please full charge the 3D glasses before the first time
using and charge the glasses at lest one time within 6 months.
Troubleshooting
What can I do if there is no 3D effect after I put on and turn on the 3D glasses?
•
Please check if the DLP projector setup is in 3D mode or not.
•
Check the battery volume of your 3D glasses,please charge it in time if low in power.
•
Make sure your position is in the sync signal coverage so that the glasses can receive the signal.
Why do the lenses blink when watching 3D films?
•
Please charge the 3D glasses immediately if the battery is seriously low.
•
If there is light or other signal interference in the watching surroundings, please turn off
interference source.
Liquid Crystal
32g
About 8m
38±2%
DLP-Link
1200:1
Polymer lithium battery
1.9mA
96Hz/100Hz/120Hz/144Hz
Sustainable work time is 30 hours after full charging
Working Temperature
Storage Temperature
3
0~40°C
-5~50°C
Advertisement
Table of Contents
