Required Time; Setting The Buzzer; Changing Settings While Washing - Panasonic NA - 148VB6 Operating Instructions & Installation Instructions

6. Press the Start button.
The appliance starts supplying water
after draining.
Note
- Whenever you start washing, the
process display flashes to show
which function is in progress.
- Before any programme is started, the
appliance first drains out any water.
The buzzer will sound and "END"
will flash on the display when the
programme has finished, and the door
will unlock immediately.
Caution
After a high temperature wash, be
careful to not burn yourself when
handling the laundry or touching
the inside of the drum.
Note
- If the detergent is not completely
removed from the laundry by using
the basic programme, use the Extra
Rinse function.
- If the load is big, the laundry may
stick to the inside of the drum. This
is normal.
- Leave the appliance door open
to allow the drum to dry out after
removing the laundry.
- Remove the laundry and rearrange
where necessary. Do not leave it in the
drum too long after the programme ends
to prevent colour transfer.
NA-148VB6_English_Pan-Euro.indb 19

Required time

Required time depends on the programme
and temperature setting.
- Actual time may differ slightly from the
displayed time.
- The displayed time includes the time
needed for the water to fill up and to
drain out, thus they vary depending on
water pressure, drainage and amount of
laundry.
- If the laundry in the drum needs to
be balanced, eg to facilitate smooth
spinning, the time will be extended.

Setting the buzzer

To turn on or turn off the buzzer which
sounds when the programme has finished,
follow these instructions.
Simultaneously press and hold the
Temperature and Time buttons for at
least 3 seconds.
The buzzer setting will be turned off after
a beep is heard.
The buzzer setting will be turned on after
two beeps are heard.
Changing settings while
washing
After washing has started, the programme,
temperature, spin speed, preset time, Extra
Rinse, Easy Iron and Speed/Eco function
cannot be changed.
To change the programme, temperature,
spin speed, preset time, Extra Rinse, Easy
Iron and Speed/Eco function settings, turn
the appliance off and then on again.
Washing Instructions - 19
Washing
2014-12-22 9:37:05