Kenmore 758.15420011 Use & Care Manual page 7

Water Fill (continued)
Place the opening of the water bottle
under a water faucet (the bottle should
fit under a four-inch clearance faucet).
Fill with recommended mixture of cold
water and an EPA approved
bacteriostat (if necessary) only.
CAUTION" Use only EPA
(Environmental Protection
Agency) approved Bacteriostat
available from Sears Retail
stores. Under no circumstances
should you use water treatment
products designed for Roto belt
or Ultrasonic humidifiers.
Solid debris could make the valve leak.
Install the "E-Z-Fill Side-Cap" by
twisting clock- wise. Hand tighten only.
Check for possible leaks by
performing the following:
1. Grasp bottle handle and hold the
bottle upright over a sink.
2. Press up on the valve cap plunger for
about one second to let out a little
water.
3. Release the plunger.
4. Listen for air bubbles Look for leaks
around the "E-Z-Fill Side-Cap'.
5. If you hear air bubbles or see leaks_
retighten the "E-Z-Fill Side-Cap" and
repeat Steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the
unit by grasping the water bottle handle
and lower it into the cabinet until the
bottle sits on pads at bottom of cabinet.
The "E-Z-Fill Side-Cap" must be facing
the rear of the cabinet. When
positioned properly, the plunger will
open and water will flow into the
cabinet. The water level will
automatically remain at approximately
1/2" until the bottles are empty.
Allow the filter to saturate for 30
minutes before operation.
Turn Counterclockwise
to Remove Cap
J
J
Valve Cap _
Plunger
Pivoting Lid Removed for Clarity
7