Setting The Date And Time; Charging The Battery Pack; Choosing The Dialing Mode - Sony SPP-VT11 Operating Instructions Manual

Table of Contents

Advertisement

2

Setting the date and time

Use the buttons on the base phone.
1 Press
flash/program
with the receiver on the base phone.
A voice guide is heard.
2 Enter the proper number for the year,
month and day.
For the year, enter the last two digits.
For example, to set the date to December 5, 2000,
press
0
0
1
2
3 Set the time.
The unit uses the 24-hour system.
To enter a number smaller than 10, press
first.
For example, to set the time to 10:06 PM, press
.
2
2
0
6
4 Press
flash/program
A beep is heard and the clock starts.
Notes
• If a power interruption occurs, the day and time will be
reset to January 1, 2000. Set the date and time again.
• If the current day and time are not set, you will not be
able to set the time for a morning call.
• If an error beep is heard after step 4, go back to step 1
and follow the steps all over again.
Make sure you enter the correct numbers in steps 2 and 3.
3

Choosing the dialing mode

This unit automatically selects the appropriate
dialing mode (tone or pulse) for your telephone line.
However, if the call cannot connect , follow the steps
below to select an appropriate dialing mode.
1 Press
flash/program
continuously with the receiver in place on
the base phone.
A voice guide is heard.
2 Press
.
3
3 Press
flash/program
A beep is heard.
4 Make a trial call.
If the call connects, your dialing system is tone.
If the call cannot connect
Your dialing system is pulse.
Repeat the above steps and press
2. If the call still cannot connect, press
in step 2.
and
continuously
2
.
0
5
0
.
,
and
3
.
(20PPS) in step
2
(10PPS)
1
4

Charging the battery pack

Warning
• Do not peel off or scratch the plastic cover on the
battery pack.
• Do not twist the cords of the battery pack.
Charge the battery pack for more than 10 hours
before you start using your phone.
1 Slide open the battery compartment lid of
the handset.
2 Connect the battery connector with the
correct polarity (black and red cords).
Red
Black
3 Hook the cords and insert the battery
pack.
4 Close the lid.
(continued)
111

Advertisement

Chapters

Table of Contents
loading

Table of Contents