Error Messages - Sharp MD-SR60 Service Manual

MD-SR60

Error Messages

ERROR MESSAGES
BATT EMPTY
BLANK MD
Can't COPY
Can't EDIT
Can't READ (*)
Can't REC
Can't STAMP
Can't WRITE
DEFECT
DISC FULL
Er-MD (**)
HOLD
LOCKED
NO DISC
Number or symbol appears in (*) position.
g
ERROR MESSAGES
NO SIGNAL
PLAY MD
POWER ?
PROTECTED
SORRY
TEMP OVER
(**)
TOC FORM
TOC FULL
Tr. Protect
? DISC
Number or symbol appears in (*) position.
MEANING
The battery is not charged or there
is no battery in the compartment.
Nothing is recorded.
You tried to record from a copy pro-
hibited MiniDisc.
A track cannot be edited.
The disc data cannot be read be-
cause the disc is damaged.
Recording cannot be performed cor-
rectly due to vibration or shock.
Stamp function does not work.
Cannot save the TOC information
correctly to a MiniDisc. (A large por-
tion of the disc has been damaged.)
The disc is scratched.
The disc is out of recording space.
The microprocessor has reported a
system fault and the unit is out of or-
der.
The unit is in the hold mode.
You removed a MiniDisc while re-
cording or editing.
A disc has not been loaded.
MEANING
Poor connection of the digital cable.
No output signal comes out from the
connected unit to playback.
You recorded on a playback-only
disc.
Improper power is being supplied.
The write protection tab of a MiniDisc
is set to the protected position.
You tried to record on a playback-
only disc.
Since a track number is currently
being located or written to, the unit
cannot accept your command.
The temperature is too high.
There is an error in the recording
signal.
There is no space left for recording
character information (track names,
disc names, etc.).
The track has been protected from
being erased.
A disc which contains data other than
music was played.
There is an error in the signal re-
corded on the disc.
REMEDY
Charge the rechargeable battery or replace the alka-
line battery (or use the AC adaptor for power).
Replace the disc with a recorded disc.
Record using the analog cable.
Change the stop position of the track and then edit it.
Reload the disc.
Replace it with another recorded disc.
*:f=focus ERROR
a=SERVO ADJUST u=UTOC READ
s=TRACK SEARCH w=Data WRITE
Re-record or replace it with another recordable disc.
Check the number of tracks.
Replace the disc with another recordable disc.
If the sound you hear is not right, record again.
Replace the disc with another recordable disc.
Replace it with another recordable disc.
To have it repaired, go to the distributor where you
purchased the unit.
**:80=EEPROM READ ERROR
41=UTOC WRITE ERROR
Return the HOLD switch to its original position.
Turn off the power and remove the MiniDisc.
Load a disc.
REMEDY
Connect the digital cable securely.
If the portable CD player has a function to prevent sound
skips, deactivate it.
Playback with the connected unit.
Replace it with a recordable disc.
Use one of the specified power sources.
Move the write protection tab back to its original position.
Replace it with a recordable MiniDisc.
Wait for a while and try the operation again.
Turn off the power, and wait for a while.
Erase all of the tracks, and then record again.
Replace it with another recordable disc.
Edit the track with the device on which it was recorded.
A disc which contains non-music data cannot be
played.
Replace it with another recorded disc.
– 6 –
r=TOC READ