Toshiba 2460 Service Handbook page 30

1.5.2 Printer unit adjustment
a) Polygonal motor 600 dpi/GDI (Primary scanning reproduction ratio of the printer unit)
(1) Make a test print as in the following procedure.
0 5
1
PWR
(2) Measure the distance "A" which is the distance between the 5th line and 15th line from the
bottom end of the test print paper against the direction of the paper movement.
(3) In order to set the distance "A" to 100 mm, adjust as follows.
4 0 1
Notes 1. An increase in the value lengthen the distance "A".
2. In order to make a test print, make sure the message indicates [ 100 %
after the INT key is pressed.
3. Adjustment value is effective within the range of 114 ~ 142.
The default adjustment value is 128.
September 1997 © TOSHIBA CORP.
FAX
Print movement direction
15
A
5
1
Set the value
START
1 - 27
1 FAX
INT
2460 ADJUSTMENT
A ]