Table of Contents
Advertisement
- Changes trigger polarity (HardwareTrigger operation only)
Set the following value to "TriggerActivation" register. Setting value is Enumeration type.
- Sets trigger delay (HardwareTrigger operation only)
Set the following value to "TriggerDelay" register. Setting value is Float type.
Adds delay time from trigger edge to exposure start.
- Sets sampling period for Anti-Chattering (HardwareTrigger operation only)
Set the following value to "TriggerSamplingPeriod" register. Setting value is Float type.
● Note
Changing "TriggerMode", "TriggerSource", "TriggerActivation" registers value is invalid during image stream
data output.
In SoftwareTrigger operation, it takes less than 1ms from "TriggerSoftware" command to exposure start.
When set longer value to "TriggerSamplingPeriod" register, noise immunity of trigger input line is improved,
but the delay time of receiving trigger signal become longer.
Copyright © 2014 TOSHIBA TELI CORPORATION, All rights reserved.
Value
FallingEdge (*)
RisingEdge
TriggerDelay
Minimum (*)
Maximum
TriggerSamplingPeriod[μs]
Minimum (*)
Maximum
Polarity
Negative
Positive
* initial factory setting
Value
0.00[μs]
4095.00[μs]
* initial factory setting
Value
2.00[μs]
1000.00[μs]
* initial factory setting
50 / 80
D4235067D
http://www.toshiba-teli.co.jp/index.htm
Advertisement
Table of Contents
