Connectors - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4 - 72
5.5.4

Connectors

The CN2 connector provides connection to four analog DID trunk
ports, which are polarity sensitive (tip-to-tip, ring-to-ring). The
OPX circuits, however, are not polarity sensitive. The DIOPU
requires one universal slot. (Refer to
Blade on page
that the blade consumes four (4DIOPU) trunks or eight (8DIOPU)
trunks and extension ports when installed. If OPX is not defined,
then only trunks ports are consumed.
Table 4-38 GCD-4DIOPB RJ-61 Cable Connector Pin-Outs on page
4-72 shows the pin-outs for the RJ-61 connector. Refer to
4-18 GCD-4DIOPB Blade on page 4-70
the location of the connectors on the 4DOIPU blade.
Table 4-38 GCD-4DIOPB RJ-61 Cable Connector Pin-Outs
4-70.) If Program 10-03-01 has OPX defined, note
RJ-61 Cable Connector – CN2
Line No.
1
2
3
4
UNIVERGE SV9100
Figure 4-18 GCD-4DIOPB
for an illustration showing
Pin No. Connection
5 Tip
4 Ring
3 Tip
6 Ring
2 Tip
7 Ring
1 Tip
8 Ring
Installing the SV9100 Blades
Figure