Table of Contents
Advertisement
8 - CLEANING AND MAINTENANCE
IMPORTANT: Before cleaning or
carrying out any maintenance dis-
connect the appliance from the elec-
trical supply and wait for it to cool
down.
ATTENTION: The appliance gets
very hot, mainly around the cook-
ing areas. It is very important that
children are not left alone in the
kitchen when you are cooking.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left in contact for too long.
PAINTED PARTS AND SILK-SCREEN
PRINTED SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive sub-
stances or non-neutral detergents as
these will irreparably damage the surface.
STAINLESS STEEL ELEMENTS
– Stainless steel parts must be rinsed
with water and dried with a soft and
clean cloth or with a chamois leather.
– For difficult dirt, use a specific non-
abrasive product available commer-
22
cially or a little hot vinegar.
WARNING
When correctly installed, your product
meets all safety requirements laid
down for this type of product catego-
ry. However special care should be
taken around the rear or the under-
neath of the appliance as these areas
are not designed or intended to be
touched and may contain sharp or
rough edges, that may cause injury.
VITROCERAMIC COOKING HOB
– See page 13
INSIDE OF OVEN
The oven should always be cleaned
after use when it has cooled down. The
cavity should be cleaned using a mild
detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations
and testing a small sample of the oven
cavity. Abrasive cleaning agents or
scouring pads/cloths should not be
used on the cavity surface.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abrasive
cleaning.
Let the oven cool down and pay spe-
cial attention no to touch the hot heat-
ing elements inside the oven cavity.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the oven is cool, unscrew and
replace the bulb with another one
resistant to high temperatures (300°C),
voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not
covered by your guarantee.
Hide quick links:
Advertisement
Table of Contents
