3
Loosen the two screws ( mark)
and lift out the lamp unit.
The screws are not taken off from the lamp unit.
Connector
4
Change the lamp unit.
Do not touch the glass inside the unit.
Dirt or fingermarks on the glass may reduce the
brightness of the lamp.
5
Replace the lamp unit and lamp
cover following the disassembly
procedures in reverse order.
Be sure that the connector of the lamp unit is
correctly connected and the lamp unit is firmly
replaced.
6
Insert the power connector into
the power terminal.
7
While pressing the MODE but-
ton, press the POWER button
three times.
All the monitors flash for a few seconds.
The lamp timer is initialized to [0 hours].
En-31