Oven Door Locks When The Oven Is Programmed For Clean But The Oven Does Not Heat - Electrolux 30" Service Manual

the control is defective. If the meter reads line to
line voltage (240 VAC) the broil element or the wiring
to the broil element is defective. Go to step 2.
2. Remove the back from the range to gain access to
the terminals of the broil element. Program the oven
control for broil and measure the voltage drop across
the terminals of the broil element. If the meter reads
line to line voltage (240VAC) the element is defective.
If the meter reads zero the wiring to the element is
open.
Oven door does not lock when the oven is pro-
grammed for clean:
1. Remove power from the range and go to the back
of the oven control. Remove the 15 pin plug and
with the oven door closed measure the resistance
between pins 5 and 6 in the plug. If the meter
reads around 2400 Ohms the control is defective.
If the meter reads open go to step 2.
2. Remove the rear cover from the range and
measure the resistance of the lock motor. If the
meter reads open the motor is defective. If the
meter reads around 2400 Ohms go to step 3.
3. Remove the right-hand bodyside and measure the
resistance between terminals NO and C of the
door switch with the door closed. If the meter
reads infinity the door switch is defective. If the
meter reads zero go to step 4.
4. Measure the resistance between pins 9 and 11 of
the 15 pin plug. If the meter reads infinity the lock
switch is defective. If the meter reads zero
replace the control.
Oven door locks when the oven is programmed
for clean but the oven does not heat:
1. If the oven operates normally in bake, replace the
control.
Lock motor runs continuously:
1. With the door in the unlock position, remove power
from the range. Go to the back of the control and
disconnect the 15 pin plug from the control. With an
Ohmmeter measure the resistance between pins 9
and 10 of the 15 pin plug (not on the EOC). If the
meter reads zero the lock switch or the wiring to the
lock switch is defective. If the meter reads infinity
go to step 2.
2. Depress the arm of the lock switch, and measure
the resistance between pins 9 and 10 of the 15 pin
plug. If the meter reads infinity the lock switch or
the wiring to the lock switch is defective. If the meter
reads zero the control is defective.
Door latch is partly closed with door open, cannot
close door:
1. Program the oven for self-clean, remove the
right-hand side panel and hold the oven door
switch closed, the latch mechanism should rotate
close. After 30 seconds touch clear and the latch
mechanism should rotate open.
Fan in oven does not run when speed bake switch
is turned on:
1. Program the oven for clean. If the door does not
lock check the door switch. If the door locks touch
clear and allow the door to unlock and go to step 2.
2. Go to the back of the speed bake switch, with the
switch in the on position measure the voltage drop
between each terminal of the switch and neutral. If
no voltage is shown from either terminal the wire
between the P7 terminal of the oven control and
the switch is open. If voltage is present on one
terminal but not the other the switch is defective. If
voltage is present on both terminals the motor or
the wiring to the motor is defective.
59