Operation Instructions Operating modes Before using the first time Exhaust-air mode: Important notes: ❑ The extractor-hood fan extracts the kit- Do not flambé food directly under the ❑ The Instructions for Use apply to several extractor hood. chen vapours and conveys them versions of this appliance.
How to operate the extractor hood Filters and maintenance If you encounter a problem Various types of grease filter can be If you have any questions or if a fault The most effective method of remo- used to absorb the grease contained in occurs, please call Customer Service.
Filters and maintenance Activated carbon filter Removing and installing the activa- Important: Extractor hoods with two filter cartridges: Metal filters that are heavily saturated with ted carbon filter Warning: The halogen bulbs must be swit- grease should not be cleaned at the same ched off and cool.
Activated carbon filter Cleaning and care Extractor hoods with two filter cartridges: Switch off the extractor hood and isola- te by pulling out the mains plug or swit- 1. Remove the filter cartridge. ❑ See grease filter. ching off the disconnector on the instal- lation side.
Page 6
Installation Instructions: Cleaning and care Important information Changing the bulbs Halogen bulbs: Old appliances are not worthless rubbish. Valuable raw materials can be 1. Switch off the extractor hood and isolate Candle bulbs: reclaimed by recycling old appliances. by pulling out the mains plug or swit- 1.
Installation Instructions: Prior to installation Important information Additional information concerning gas Exhaust-air mode cookers: When installing gas hotplates, comply with the relevant national statutory regulations (e.g. in Germany: Technische Regeln Gasinstallation TRGI). Always comply with the currently valid regulations and installation instructions sup- plied by the gas appliance manufacturer.
Prior to installation Electrical connection Installation Extractor hoods with 150 mm Ø air The extractor hood must be connected to The extractor hood is particularly suitable outlet: a correctly installed earthed socket only. for installation in a flue or chimney. 150 mm l extraction pipe Attach the earthed socket as close to the To ensure optimum extraction perfor-...
Page 9
Installation Extractor hood with slide control, 53 cm Extractor hood with slide control, 73 cm 1. Remove the filter grille (see operating wide, 1 and 2-motor: wide, 1 and 2-motor instructions). 2. Connect the power. 3. Press the extractor hood up into the installation opening until the installation aid locks into position at the front and rear.
Page 10
Removal 1. Loosen the screws. 2. Hold the underside of the extractor hood, Hold the underside of the extrac- tor hood. Installation spring 3. Lower the extractor hood and remove.