Yamaha 2004 YP400 Service Manual page 20

FEATURES
Clock mode
To set the clock:
1. Push the "SELECT" button and "RESET"
button together for at least two seconds.
2. When the hour digits start flashing, push
the "RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the min-
utes.
5. Push the "SELECT" button and then
release it to start the clock. Pushing the
"RESET" button for at least two seconds
switches the clock display to the ambient
temperature display.
Ambient temperature display
This display shows the ambient temperature
from –10 °C to 50 °C in 1 °C increments. The
temperature displayed may vary from the
ambient temperature. Pushing the "RESET"
button for at least two seconds switches the
ambient temperature display to the clock dis-
play.
• When the ambient temperature falls below
–10.0 °C, "–10.0 °C" is displayed.
• When the ambient temperature climbs
above 50.0 °C, "50.0" is displayed.
NOTE:
• If "– – °C" is displayed or "50.0" flashes while
the ambient temperature is between –10.0 °C
and 50.0 °C, there is a problem with the elec-
trical circuit. Check or repair the electric cir-
cuit or replace the thermistor.
• The accuracy of the temperature reading
may be affected when riding slowly (approxi-
mately under 20 km/h) or when stopped at
traffic signals, railroad crossings, etc.
1 - 9
GEN
INFO