Operation - Bosch 0 275 007 025 Owner's Manual

Operation

Initial Operation
Switching the eBike System On/Off
Options for switching on the eBike system:
– If the display unit is already switched on when inserted
into the holder, then the eBike system will be switched
on automatically.
– When the display unit and the battery pack are inserted,
briefly press the On/Off button 5 of the display unit
once.
– When the display unit is inserted, press the On/Off but-
ton on the battery pack.
The motor assistance is activated as soon as you step on
the pedals (except when in the "OFF" assistance mode).
The motor assistance depends upon the settings of the dis-
play unit.
As soon as you stop pedaling when in normal operation, or
as soon as you have reached a speed of 20 mph, the assis-
tance from the eBike drive unit is switched off. The motor
assistance is automatically re-activated as soon you start
pedaling again and the speed is below 20 mph.
Options for switching off the eBike system:
– Press the On/Off button 5 of the display unit.
– Switch the battery pack off by using its On/Off button
(see battery pack operating instructions.)
– Remove the display unit out of its holder.
If no power is drawn from the drive unit for about
10 minutes (e.g., because the eBike is not moving), the
eBike system will shut down automatically to save energy.
6
5
4
Bosch eBike Systems
1
2
3
Indications and Settings of the display unit
g
f
e
Switching the display unit On/Off
To switch on the display unit, briefly press the On/Off but-
ton 5. When the internal battery pack is sufficiently
charged, the display unit can also be switched on when not
inserted in the holder.
To switch off the display unit, press the On/Off button 5.
When the display unit is not inserted in the holder and no
button is pressed, it automatically switches off after 1 min
to save energy.
Battery charge-control indicator
The battery pack charge-control indicator g indicates the
charge condition of the eBike's battery pack, and not the
charge condition of the display unit's internal battery. The
charge condition of the eBike's battery pack can also be
read from the battery pack's LEDs.
On indicator g, each bar of the battery pack symbol is
equivalent to a capacity of approx. 20 %:
The battery is fully charged.
The battery should be recharged.
Once there are no remaining LED bars illuminated
on the charge-control indicator, the motor support
is gently switched off and the charge-control indica-
tor begins to flash. The flashing charge-control indi-
cator means there is only enough battery power re-
maining to power the eBike lights for approximately
2 more hours. This does not account for other con-
sumers (e.g., automatic gearbox, charging external
devices at the USB port).
When the display unit is removed from holder 4, the last in-
dicated battery pack charge condition is stored.
Setting the Assistance Level
The level of assistance of the eBike drive unit when pedal-
ing can be adjusted via the operating unit. The assistance
level can be changed anytime, even during riding.
English–11
TURBO
a
SPORT
TOUR
b
ECO
OFF
c
MPH
KM/H
AMM
PMWH
MIN
MPH
KM/H
Range
d
0 276 001 SPUen | (23.4.14)