Rec/Play - Panasonic AG-CPD20P Operating Instructions Manual

Administrator Setup

Rec/Play

Page 1
PowerOff Time
Use this function to set the interval after which the Remote
Control Panel and the recorder will shut down after the
ignition switch has been set to the LOCK (OFF) position.
Setting : 0 min, 10 min, 20 min, 30 min, 60 min, 90 min,
120 min, 180 min, AUTO
Init Preset Select
Select a Preset number when the power is turned on. Only
the preset numbers set on the Video Allocation screen are
selectable. For example, if only Preset 1 and Preset 2 have
been set, Preset 3 cannot be selected.
Setting: PRESET 1, PRESET 2, PRESET 3, LAST
Init VIDEO OUT1
Select a signal output from the [VIDEO OUT 1] connector on
the recorder when the power is turned on. Only the cameras
set to ON on the Video Allocation screen are selectable.
For example, if CAM3 has been set to OFF, CAM3 is not
selectable.
Setting: CAM1, CAM3, VIDEO OUT2, LAST
PowerOn Rec
Use this function to set recording to start when the recorder
is turned on.
Setting: OFF, ON
*
1 When recorder operation is not controlled by a Front-End or
Back-End application:
Power is turned off immediately. Note, however, that power is not
turned off while data is exported to a USB memory device, but is
turned off after completion of data export.
When recorder operation is controller by a Front-End or
Back-End application:
Power is turned off when control from a Front-End or Back-
End application is released, uploading, streaming, administrator
setup, or updating is finished on the Back-End application, or the
SDHC Memory Card slot cover is opened.
(continued)
*
1
*
2
*
2
Loop Rec
Use this function to continue recording new video while
deleting the oldest recorded files if no space is available on
an SDHC Memory Card.
Setting: OFF, ON
Notes:
• If Upload Mode on the Management Mode screen is set to
AUTO, the setting is fixed to OFF, and loop recording will
be disabled.
• If Loop Rec is set to ON, the Upload Mode on the
Management Mode screen cannot be set, and uploading
is disabled.
Intermittent Rec
Use this function to record one video frame per second
Setting:OFF, ON
Rec Continue Time
Use this function to set recording continue time for normal
recording when a trigger is entered or when the [REC] button
is pressed.
Setting: CONTINUE, 1 min, 2min, 5min, 10 min, 15 min,
20 min, 30 min, 60 min, 90 min
If uploading or exporting continues for more than three hours, it
will be interrupted to save battery charge, and the power will be
shut off.
*
2 Applies the setting in effect when power was last turned off.
Unless power is turned off properly, the operating state may not
be saved correctly.
*
3 Normal recording records 10 or 30 video and audio frames per
second.
*
4 Intermittent recording does not stop with the time set on Rec
Continue Time.
81
*
4
*
.
3