Temperature Adjustment; Extra Rinse; Delayed-Start Time; Start/Pause - Electrolux Washing machine Service Manual

4.5.18 Temperature adjustment

Used to select the washing temperature compatibly with the limit temperature for the cycle.
Can be used during the cycle selection phase: the temperature can be modified only if the heating
phase has not started (in pause mode)

4.5.19 Extra rinse

Adds two rinses in the COTTON, SYNTHETICS and DELICATES cycles.
Eliminates the intermediate spin cycles, with the exception of the final rinse, which is reduced to 450 rpm.
To select the extra rinse option, after selecting a
COTTON or SYNTHETICS or DELICATES cycle, push
simultaneously buttons 4 and 5 for at least 2 seconds,
until the corresponding phase LED lights.
This option remains always active in the following cycles;
to disactivate it, repeat the same procedure: press
buttons PREWASH (no. 1) and no. 3 simultaneously for
at least 2 seconds, until the extra rinse LED switches off.

4.6 Delayed-start time

•
Models with digit:
During the programme selection phase, it is possible to select a delayed
start from 30 minutes up to 24 hours (
24h 0h).
During the countdown, the time decreases every hour up to 2h, then by
30 minutes.
To start the cycle immediately, after the countdown has commenced:
press the Start/Pause button, cancel the delay time by pressing the
relative button and press Start/Pause again.
•
Models with LED
Insert a pause before the start of the programme, the delay time is
indicated by the corresponding LEDs.
To start the cycle immediately, after the countdown has commenced:
press the Start/Pause button, cancel the delay time by pressing the
relative button and press Start/Pause again.

4.7 Start/Pause

•
Start: After selecting the programme and the desired options, press the
START button to start the programme. If a delay time has been selected,
the countdown will start and the display will indicate it. The LED stops
flashing and remains lit for the whole duration of the programme.
•
Pause: By pressing the button again, the current programme is interrupted
and the display, or the relative LED, starts flashing. In pause mode it is
possible to open the door on condition that the machine is not performing a
heating phase, the water level is not high and the drum is not in movement.
•
When the appliance is paused, the programmes can be modified as
follows:
- All the cycle OPTIONS can be modified before the beginning of the
phase to be modified.
- the SPIN can be modified before the start of the final spin cycle.
•
To re-start the programme, press the START/PAUSE button again.
SOI/DT 2005-07 dmm
30' 60' 90' 2h
12/59
3h...
599 37 22 15