Cisco 860, 880, 890 Series
Remove the protective tape from the adhesive on the bottom of the antenna cradle, then firmly press the
Step 8
cradle to the flat surface.
Installing the 3G Adapter for Extended Cable/Antenna
For better signal and reception, if you are using the Cisco 3G Adapter for Extended Cable/Antenna,
3G-ACC-SMKTS9-TNC, follow these steps to install it:
Locate and remove the Phillips screw on the left side of the router as shown in
Step 1
screw aside for Step 4.
Figure 3-20
1
Cisco Integrated Services Router Hardware Installation Guide
3-24
Locating the Phillips Screw
Phillips screw on the left side of router
2
1
2
2
Air vent holes to be aligned with adapter
Chapter 3
Connecting the Router
Figure
3-20. Keep the