Firmware Updating With Download Jig (E-Studio202L/232/282) - Toshiba e-studio200l Service Manual

6.2 Firmware Updating with Download Jig
(e-STUDIO202L/232/282)
In this equipment, it is feasible to update the firmware automatically by connecting the download jig
using the dedicated connector and turning ON the equipment.
The download jig consists of the ROM, in which the program is written, and the jig board.
And two types of the download jigs are available for each type of the firmware.
For updating the firmware, in addition to the current ways such as updating each firmware individually,
the batch update of the firmware of the equipment is available (except the hard disk and the option).
Firmware
System ROM
Engine ROM
Scanner ROM
RADF ROM
Finisher ROM
(Finisher firmware)
Finisher ROM
(Saddle stitcher firmware)
FAX ROM
Refer to the following for the details to update with each download jig.
P.6-33 "6.2.1 PWA-DWNLD-350-JIG2 (48 MB)"
P.6-42 "6.2.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
June 2004 © TOSHIBA TEC
Stored
System control PC board
(SYS board)
Logic PC board
(LGC board)
Scanning section control PC
board
(SLG board)
RADF control PC board
(MR-3020)
Finisher control PC board
(MJ-1025)
Finisher control PC board
(MJ-1024)
FAX board (GD-1150)
6 - 31
05/11
Download jig
Batch update
PWA-DWNLD-350-
JIG2 (48 MB)
-
-
-
-
e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
Individual update
-
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
6