16
NOTE When using the application on your mobile computer in "Pick List" mode,
the Bright Center Dot can be positioned anywhere on the symbol.
@1234@
Right
The aiming pattern is smaller when the Imager is closer to the symbol and
larger when it is farther from the symbol. Scan symbols with smaller bars
or elements (mil size) closer to the Imager and those with larger bars or
elements (mil size) farther from the Imager.
Hold the Imager between two and eleven inches from the bar code (depending
2.
on the bar code density).
NOTE When a symbol is under transparent plastic or on a mobile computer
screen, it is recommended to use a tilt (pitch) or skew scan angle to avoid
reflection.
Press the Scan Button. The aiming pattern illuminates red indicating that the
3.
laser is on. One green flash of the Scan LED and a high beep indicates that a
bar code was properly decoded.
Customize the Imager
Changing from Trigger to Triggerless Configuration
To Change from Trigger to Triggerless configuration:
Remove the Comfort Pad (See
1.
Remove the Trigger Swivel Assembly (See
2.
Replacement on page
Install the Triggerless Strap Holder (See
3.
on page
22).
Install the Comfort Pad (See
4.
Perform a cold boot (See
5.
Changing Triggerless to Trigger Configuration
To change from Triggerless to Trigger configuration:
Remove the Comfort Pad (See
1.
Remove the Triggerless Strap Holder (See
2.
(Triggerless Strap Holder) on page
Comfort Pad Replacement on page
21).
Comfort Pad Replacement on page
Cold Boot on page
Comfort Pad Replacement on page
24).
RS507 Hands-Free Imager
@1234@
Wrong
Trigger Swivel Assembly
Triggerless Strap Holder Replacement
18).
Finger Strap Replacement
21).
21).
21).