Advertisement
General
Turn the warmer
drawer
control
knob to OFF
before removing
the drawer.
DO
NOT touch the warmer
drawer
element.
The element
may still be
hot enough to cause burns, even
if it is dark in color.
Cleaning Ccont nuedl
To Remove and Replace Warmer
To Remove
Warmer
Drawer:
Warmer Drawer
.
2.
3.
4.
.
6.
Drawer
Turn power off before
removing the warmer
drawer.
Open the drawer
to the fully opened
position.
Locate the latches on both sides of the warmer drawer.
Pull up on the left glide latch and push down on the right glide
latch.
Pull the drawer
away from the appliance.
To clean warmer drawer, gently scour with a soapy scouring
pad;
this will remove most spots. Rinse with a 1:1 solution of clear water
and ammonia.
If necessary,
cover difflcult
spots with an ammonia-
soaked paper towel for 30 to 40 minutes. Rinse with clean water
and a damp cloth. Remove all cleaners or the porcelain
may
become damaged
during future heating.
DO NOT use spray oven
cleaners on the cooktop.
To Replace
Warmer
Drawer:
1. Align the glide latches on both sides of the drawer
with the slots on
the drawer.
2.
Push the drawer
back into the appliance.
Electrical Shock Hazard can occur and
result in serious injury or death.
Disconnect
appliance
from electric
power before
cleaning
and servicing
the
warmer
drawer.
Avoid Service Checklist
Before you calt for service, review this list. It may save you time and
expense.
The list includes common
occurrences that are not the result
of defective
workmanship
or materials
in this appliance.
OCCURRENCE
POSSIBLE
CAUSE/SOLUTION
Drawer
is not level.
Poor installation. Place a level on the cutout bottom.
Make sure bottom
is level.
Cannot move appffance
easffy. Appffance must be
accesslble for service.
Warmer drawer
does not
operate.
Be sure cutout
bottom
is strong and stable enough to adequately
support
drawer
(and wall oven, if applicable).
Cabinets
not square or are built in too tightly.
Contact
builder or installer to
make appliance
accessible.
Make sure cord/plug
is plugged
tightly
into outlet.
Service wiring
is not complete.
Contact
Sears or another
qualified
servicer.
Power outage.
Check house lights to be sure. Call your local electric
company
for service.
An error at power up (or after a power failure)
could happen
if the control
knob was left on the ON position.
If a power failure
should occur, be sure to
set the control
knob to the OFF position.
This will reset the electronic
controls.
Once the control knob has been set to the OFF position,
the electronic
controls
should return to normal operation.
Advertisement
