Table of Contents
Advertisement
Note:
• To use this function:
- Set Speclker Preference to Audio Receiver in
the REGZA-LINK Setup menu
- Confirm that a connected REGZA-L1NK device
(such as DVO player, etc) is selected for the
Audio Receiver input source.
• You can also use this function when the audio
receiver is connected to the TV's DIGITAL
AUDIO OllT terminal (not HOMI connection).
In this case, select a digital audio input mode
on the Audio Receiver
• These functions depend on the device
connected.
Other RE('l,A·LlNK® functions
When the
Enable REGZA-L1NK
and each item in the
REGZA-L1NK SEltUP
menu are set to
On,
the following
functions will be enabled.
To set the REGZA-LINK® Setup:
1
From the
Setup
menu, highlight
REGZA-L1NK
Setup
and press
8.
2
Press
or ..... to highlight
Enable REGZA·L1NK.
3
Press
or
~
to select
On.
Note: If you select Enable REGIA-LINK Off, the
other items will be grayed out.
4
Press .... or ..... to highlight the
REGZA-L1NK Setup
item you want to use, and press .... or
~
to select
On
or desired mode.
• TV Auto Input Switch: On/Off
• TV Auto Power: On/Off
• Device Auto Standby: On/Off
• Speaker Preference: TV Speakers/Audio Receiver
5
To save the new settings, highlight
Done
and press
8.
To revert to the factory defaults, highlight
Reset
and press
8.
Note: When you turn on the Audio Receiver,
change its input source, or adjust the sound
volume, the sound will be output from the audio
receiver's speakers even if TV Speakers has
been selected. Turn the TV off and on again to
output the sound from the TV speakers.
TV Auto
Input Switch
TV Auto
Power
Device Auto
Standby
Speaker
Preference
If a connected HDMI device starts
playing video or audio, the TV will
automatically switch to the appropriate
HDMI input.
If a REGZA-LINK device is tumed on,
the TV tums on automatically.
If the TV is tumed off the TV will send
a message to turn off all of the REGZA-
LINK devices connected to the TV
From this item, you can set your audio
output preference to the TV speakers
or the audio receiver speakers. When
this item is set to Audio Receiver,
the TV remote can be used to adjust
or mute the volume of the audio.
This item will be grayed out unless
a REGZA-LINK compatible audio
receiver is connected.
Displaying TV status information
To display TV status information using
RECALL:
Press
I
RECAliJ
on the remote control.
The following information will display (if applicable):
• Current input
(ANT/CABLE, VIDEO,
etc.)
• If ANT/CABLE is the current input, either "CABLE"
(for cable TV) or "ANT" (for over-the-air broadcasts).
• Channel number (if in
ANT/CABLE
mode)
• Channel label (if applicable)
• Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
• Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
• GameTimer (if set)
: _ , .t··t1Mil'M""""am-kb4t1
W
':
.
To close the RECALL screen:
Press
I
RECAll
I
again.
(continued)
49
I
Advertisement
Table of Contents
