FCC COMPLIANCE STATEMENT INFORMATION TO THE USER: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THE EQUIPMENT IS OPERATED IN A COMMERCIAL ENVIRONMENT.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. DO NOT INSERT ANY METALLIC OBJECT THROUGH VENTILATION GRILLS. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER(OR BACK).
IMPORTANT SAFEGUARDS READ INSTRUCTIONS -- All the safety and operating instructions should be read before the appliance is operated. RETAIN INSTRUCTIONS -- The safety and operating instructions should be retained for future reference. CLEANING -- Unplug video monitor or equipment from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
Page 5
POWER CORDS -- Do not allow anything to rest on the power cord. Do not locate video monitor or equipment where the cord will be abused by persons walking on it. HEED WARNINGS -- Follow all instructions marked on the video monitor or equipment. LIGHTNING -- For added protection for video monitor or equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system.
CHAPTER 1: INTRODUCTION Video Camera HMC21 Monitor Figure 1 - Typical configuration FEATURES · Convenient front panel controls · 21'' flat, square picture tube · OSD (on-screen display) setup menus · Menus in English, French, Italian, German and Spanish · NTSC and PAL compatible ·...
TECHNICAL OVERVIEW The HMC21 is a 21-inch color monitor with on-screen display(OSD) setup menus. The setup menus are switchable between English, French, Italian, German and Spanish. The HMC21 has multiple video and audio inputs and outputs. The user can switch between two video sources. The monitor has S-VHS connectors for the best quality video when connected to a compatible VCR.
CHAPTER 2: INSTALLATION Power OSD Menu Under Scan Cursor Down Cursor Up Video Input Decrease Adjustment Increase Adjustment Figure 2 - Front panel controls VIDEO LINE AUDIO LINE VIDEO A VIDEO B POWER POWER Audio Out "B" Video "A" In BNC Audio In "B"...
REQUIRED INSTALLATION TOOLS Installing the HMC21 monitor does not require any special tools. INSTALLATION INSTRUCTIONS WARNING : The monitor should be installed in an area that is clean, dry and well ventilated. Do NOT install the monitor where it can get wet; such as near pools, sinks, open windows, etc.
The S-VHS connectors can be used with VCRs that have S-VHS input and output connectors. Pin 4: C Signal Pin 3: Y Signal Pin 2: Ground Pin 1: Ground Figure 5 - Y/C Mini DIN connector configuration If your plan to loop the video out to another monitor, connect a cable to the Video Out BNC and route it to the Video In...
CHAPTER 3: OPERATION OSD Menu Power Cursor Down Under Scan Cursor Up Video Input Decrease Adjustment Increase Adjustment Figure 7 - Front panel controls To turn on the monitor, press the power button on the front panel. After a few seconds, video should appear on the monitor.
English : Selects the menu language. English is the factory default. The user can select from English, French, German, Italian, Spanish and Polski. VOLUME CONTRAST BRIGHTNESS SHARPNESS COLOR TINT H-POSITION V-POSITION ENGLISH NEXT PAGE Figure 8 - OSD Menu NEXT PAGE is used to adjust for the skew distortion of a video from s recorder.
APPENDIX A : TROUBLESHOOTING PROBLEM POSSIBLE SOLUTION No Video Check that all components in the system (monitor, cameras, VCRs, multiplexers, etc.) have power and are turned on. Check that the camera lens cap is removed and the lens is set to proper aperture. Check cable(s) for proper connections and condition.
APPENDIX B : SPECIFICATIONS PICTURE TUBE 12'' Flat, Square Tube Phosphor Dot Pitch In-line, 0.74mm stripe Deflection 90 angle POWER SOURCE 90 to 254VAC, 50Hz or 60Hz VIDEO STANDARD NTSC and PAL (automaticly detects) RESOLUTION Horizontal : 450 TV lines SCANNING FREQUENCY Horizontal 15.75KHz (NTSC);...
Page 16
All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell Video Systems. The information in this publication is believed to be accurate in all respects. However, Honeywell Video Systems cannot assume responsibility for any consequences resulting from the use thereof.