Thermal cut-out
This machine has a resettable heater
limiter which will shut off the elements in
the event of over-heating. This could be
caused for example, by large articles
covering the heating elements or if the
filters in the wash cabinet are blocked.
If the fault code: F01 - F03, F18, F19
(water was not heated up in the wash
cabinet and the programme is taking
too long), proceed as follows:
^ Remove the cause of the fault.
^ Remove the service panel.
^ Press the reset button on the heater
limiter located on the right-hand side
of the plinth.
If this switch trips again, contact the
Miele Service Department.
Other problems
57