Troubleshooting - Sanyo SBM-201 Instruction Manual

PROBLEM POSSIBLE CAUSE SOLUTION
S:01APPEARS IN
+Bread maker is too hot to use and =Open lid and
remove bread pan.
)ISPLAY WINDOW
should be cooled down. Allow bread maker to cool down for
about 30 minutes. Display panel will
clear when machine is cool.
202, E:03, E:04,E:05,
+Bread maker malfunction. =AJnplug bread maker and refer to the
3R
E:08 APPEARS IN
dealer or the approved SANYO
rHE DISPLAY
Service Center for repair.
WINDOW
3URNING SMELL
+Ingredients were spilled inside the +Be careful not to spill ingredients
)URING OPERATION
cavity of bread maker. when adding them while a recipe is
mixing and kneading, This is very
important when using "add
ingredient" phase. Always add
ingredients very slowly.
+Ingredients exceeded the capacity +Check to make sure ingredients did
allowed for machine, and spilled into not exceed amount allowed for
machine cavity. machine capacity. Measure
carefully.
3READ IS NOT
+Too many ingredients were used,
-Always measure ingredients carefully.
hllXING PROPERLY
and the machine stopped. Empty bread pan, measure
4ND MACHINE
ingredients again, and start over.
STOPPED
+Too many ingredients were used, -The bread maker motor must be
causing a motor overload, and the replaced. Refer to the dealer or the
motor fuse blew. approved SANYO Service Center for
+Kneading blade is not rotating
repair.
smoothly on shaft. Ingredients may
have been discharged or leaked out +. Refer to the dealer or the approved
onto shaft unit, inhibiting smooth SANYO Service Center for repair.
rotation.
MACHINE STOPS
A power failure has occurred.
+If operation stopped prior to the final
)URING OPERATION
rise, course can be started over.
After the final rise, but before baking,
dough can be removed from the
bread pan and shaped by hand.
Allow to rise until almost double in
size and bake in conventional oven.
+Bread maker malfunction. -Refer to the dealer or the approved
SANYO Service Center for repair.
NOTHING APPEARS
+Check to make sure bread maker is =Make sure machine is plugged in.
N DISPLAY WINDOW
plugged in.
WHEN START IS
+A power failure may have occurred.
-Press START again.
PRESSED
+Bread maker malfunction.
=Refer to the dealer or the approved
SANYO Service Center for repair.
BREAD MAKER DOES
+Bread maker may not be plugged in. -Check to see if bread maker is
NOT START AND
plugged in.
NOTHING APPEARS
+A power failure may have occurred
-Press START again.
N DISPLAY WINDOW
at the same time you attemped to
start machine.
+Machine has a malfunction. 4Jnplug bread maker and refer to the
dealer or the approved SANYO
Service Center for repair.
20