Removing The Sensor (Gas Dryers); Removing The Combustion Chamber (Gas Dryers); Removing The Duct And Heat Shield (Gas Dryers) - Electrolux 27" Electric Dryers Service Manual

Removing the sensor: (Gas dryers)
1. Disconnect the dryer from electrical supply and
remove the front panel.
2. Disconnect the two wires from the sensor.
3. Remove the one screw holding the sensor to the
combustion chamber.
Removing the combustion chamber: (Gas dryers)
1. Disconnect the dryer from electrical supply,
remove the sensor and gas valve assembly.
2. Remove the two screws holding the combustion
chamber to the base, raise the end and pull the
chamber out of the duct.
Removing the duct and heat shield: (Gas dryers)
1. Disconnect the dryer from electrical supply,
remove the drum.
2. Remove four screws holding the heat shield to the
rear panel.
3. Lift the shield and duct out of the dryer and remove
the three screws holding duct to the heat shield.
.
78