4.6 Operation Mode
The printer can be operated in either of 5 operation modes. The modes are switched over by command
from the printer controller or change of printer operation, etc.
Proceeding from power ON, low power mode or sleep mode to standby mode will take place after going
through a warm up stage.
- Initializing mode
State in initializing.
Fixing system:
Exposure system:
Recording system:
- Running mode
State in running or recording operation.
Fixing system:
Exposure system:
Recording system:
- Ready mode
Ready state
Fixing system:
Exposure system:
Recording system:
- Sleep mode
Complete resting state. Compatible to E-Star and BAM requirement.
Fixing system:
Exposure system:
Recording system:
- Deep sleep mode
Resting state from the sleep state.
Fixing system:
Exposure system:
Recording system:
4.7 Warm-up Time
When nominal voltage (100V, 115V, 220V) is applied, the printer will proceed to standby mode from
POWER-ON within 16 seconds.
Reference: Measured at 22°C, 55% RH, nominal voltage, plain paper mode.
Stop status
Operating status (during calibration)
Operating status (during calibration)
Held at operating temperature.
Operating status
Operating status
Held at ready temperature.
Stop status
Stop status
Stop status
Stop status
Stop status
Stop status
Stop status
Stop status
8 – 8
Chapter 8 Printer Specifications