The Maintenance Console Software (Mcs); Installing The Mcs - Panasonic KX-TDA0480 Getting Started Manual

4.1 The Maintenance Console Software (MCS)

4.1 The Maintenance Console Software (MCS)
MCS provides easy-to-use installation and management of the IP Gateway Card. This section
describes the procedures to install and configure the IP Gateway Card for basic use. Use the
MCS when installing the IP Gateway Card for the first time to establish the unit's new IP
addressing through direct RS-232C link to the unit. Once this is done and units are on-line in
the network, the MCS can be used to configure and troubleshoot units remotely.
For a complete listing of all MCS features and functions, refer to the IP Gateway Card
Programming Guide.
System Requirements
• Microsoft® Windows® 95, Windows 98 or Windows NT 4.0® or later
• Minimum requirements (for installing Maintenance Console Software only)
Trademarks
• Microsoft, Windows and Windows NT are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
• Pentium is a trademark or a registered trademark of Intel Corporation or its subsidiaries
in the United States and other countries.
• All other trademarks identified herein are the property of their respective owners.

4.1.1 Installing the MCS

The MCS is shipped on CD-ROM.
20 Getting Started
CPU: Pentium® ??? MHz
RAM: ??? MB
HDD: ??? MB
1. a.
Insert the CD-ROM into the PC's CD-ROM
drive.
b.
Click "Maintenance Console Software
Installer" on the initial screen.
c.
Click [OK].
d.
Double-click "Setup.EXE" icon.
2. Follow the instructions to install the MCS.