Deactivation Character
This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page
1252), page A-2, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
ASCII character. Scan
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Default = Medium.
Short (500 ms)
Long (1000 ms)
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the following bar code, then set the delay (from 0-30,000 millisec-
onds) by scanning digits from the
Programming Chart
Save
to finish.
Deactivation Character
Programming
Chart, then scanning Save.
User-Specified Reread Delay
to read the alphanumeric combination that represents that
On
ASCII Conversion
* Medium (750 ms)
Extra Long (2000 ms)
4 - 13