Using System Functions From The Outside (Disa: Direct Inward System Access) - Siemens HiPath 2000 Operating Instructions Manual

Using Other Functions
Step by Step
90
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your ser-
vice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code: #0 ! Page 88
• Call forwarding, code:
• Lock and unlock all phones,
code: 66/#66 ! Page 80
*
• Save PIN,
code: 93 ! Page 82
*
• Send a message,
code: 68/#68 ! Page 83
*
• Leave an advisory message,
code: 69/#69 ! Page 85
*
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
code: 86/#86 ! Page 77
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code:
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the system. Enter the station number
(contact your service personnel).
o
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r
Enter the code (necessary only if programmed in the
system).
1/#1 ! Page 23
*
81/#81 ! Page 97
*
85/#85 ! Page 97
*
87/#87 ! Page 54
*
61 ! Page 38
*
89/#89 ! Page 39
*
90/#90 ! Page 95
*
97/#97 ! Page 76
*
98/#98 ! Page 76
*
7 ! Page 43
*
83 ! Page 89
*