Event Setup - D-Link DNR-326 User Manual

Section 3 - Configuration
Step 1: Select an event below.
• Connection Lost: If the connection between the camera and the
DNR-326 is lost, this event will be triggered.
• Motion from Camera: If motion is detected by this camera, this event will
be triggered.
• Input: Any external input can be used to trigger this event.
• Hard Disk Space Full: When the Overwrite function is not enabled, the
NVR will stop recording when the HDD is full.
Step 2: Click Add to select an action for the event:
• Output: When an event occurs, a signal will be sent to other connected
devices.
• Email: When an event occurs, an e-mail notification will be sent to the
specified e-mail address.
• CMS: When an event occurs, a signal will be sent to CMS.
• Push Notification: When an event occurs, an instant message will be sent
to the registered mobile clients. Mobile users can view recorded video of
the event through their mobile clients.
• E-map Popup: When an event occurs, an E-map will pop up with an event
indicator to show the location of the event.
Step 3: Click the action you want to use, and then click Configure to modify
the details of that action if necessary.
Step 4: Repeat steps 2 and 3 to add more actions, or click the Save button to
save your changes.
D-Link DNR-326 User Manual

Event Setup

30