Display Assembly and Display Latch : Dell Latitude C400 Service Manual
Back to Contents Page
Display Assembly and Display Latch
Dell™ Latitude™ C400 Service Manual
Removing the Display Assembly
Replacing the Display Latch
Removing the Display Assembly
NOTICE:
You must remove the display assembly before you remove the palm rest.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE:
Read
procedure.
1. Remove the battery.
2. Remove the
hard
3. Remove the
center
4. Close the display.
5. Turn the computer over and remove the two M2.5 x 6-mm screws at the bottom back
corners of the computer.
Display Screws
file:///F|/Service%20Manuals/Dell/Latitude/c400/display.htm (1 of 5) [2/28/2004 7:51:02 AM]
"Preparing to Work Inside the
drive.
cover.
Computer" before performing the following