Application Rules - D-Link DIR-615 User Manual

Section 3 - Configuration
Some applcatons requre multple connectons, such as Internet gamng, vdeo conferencng, Internet telephony and others. These applcatons
have dfficultes workng through NAT (Network Address Translaton). Specal Applcatons makes some of these applcatons work wth the DIR-615.
If you need to run applcatons that requre multple connectons, specfy the port normally assocated wth an applcaton n the "Trgger Port" field,
select the protocol type as TCP or UDP, then enter the firewall (publc) ports assocated wth the trgger port to open them for nbound traffic.
The DIR-615 provdes some predefined applcatons n the table on the bottom of the web page. Select the applcaton you want to use and enable
t.
Name:
Enter a name for the rule. You may select a pre-defined
applcaton from the drop-down menu and clck <<.
Trigger:
Ths s the port used to trgger the applcaton. It can be ether
a sngle port or a range of ports.
Traffic Type:
Select the protocol of the trgger port (TCP, UDP, or Both).
Firewall:
Ths s the port number on the Internet sde that wll be used
to access the applcaton. You may define a sngle port or a
range of ports. You can use a comma to add multple ports
or port ranges.
Traffic Type:
Select the protocol of the firewall port (TCP, UDP, or Any).
Schedule:
The schedule of tme when the Applcaton Rule wll be
enabled. The schedule may be set to Always, whch wll allow
the partcular servce to always be enabled. You can create
your own tmes n the Tools > Schedules secton.
D-Lnk DIR-615 User Manual

Application Rules

33