Table of Contents
Advertisement
Periodic maintenance and adjustment
ESU11835
Adjusting the throttle cable free
play
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Remove the shroud. (See page 46 for re-
moval procedures.)
3.
Remove the headlight unit bolt on each
side of the snowmobile and loosen the
quick fastener screws shown on the top
cover.
1. Headlight unit bolt
1. Quick fastener screw
4.
Disconnect the multi-function meter unit
coupler and headlight couplers, and then
remove the headlight unit.
5.
Loosen the locknut.
6.
Turn the adjusting bolt in or out until the
specified throttle cable free play is ob-
tained.
50
2
1
1. Locknut
2. Throttle cable free play adjusting bolt
3. Throttle cable free play
Throttle cable free play:
2.0–3.0 mm (0.08–0.12 in)
7.
Tighten the locknut.
8.
Connect the multi-function meter unit
coupler and headlight couplers, and then
install the headlight unit, making sure to
fit the slots on its bottom over the projec-
tions on its stay.
1. Slot
2. Projection
9.
Install the headlight unit bolts, and then
tighten them to the specified torque.
Headlight unit bolt tightening torque:
3 Nm (0.3 m·kgf, 2.2 ft·lbf)
10. Tighten the quick fastener screws on the
top cover.
11. Install the shroud.
3
1
2
Advertisement
Table of Contents
