Led Indicators - Motorola FR68 Series User Manual

LED Indicators

The FR68 Series has three LED indicators. The Scan/Decode LED indicates status for bar code
scanning. The Charging/Battery Status LED indicates battery charging and status. The Radio Status
LED indicates radio status.
Figure 2-9
1. Scan/Decode LED
2. Charging LED
3. Radio Status LED
Table 2-6
LED Status
Scan/Decode LED
Single blinking green
Solid red
System Led (Amber blink)
Off
Charging/Battery Status LED
Off
Slow blinking amber
Solid green
Fast blinking amber
Fast blinking red
Single blinking amber (when the device is
turned on)
Radio Status LED
Slow blinking green
Slow blinking red
Off
NOTE
Table 2-8
LED Indicators
LED Indications
For information about scanning/decoding, see
WAN radio status and settings, see
describes the LED indications.
Indication
Barcode was successfully decoded.
Laser enabled, scanning in process
The behavior of this LED controlled by Microsoft
system.
Not enabled
FR68 Series is not charging.
FR68 Series is not inserted correctly in the cradle
or connected to a power source. Charger/cradle is
not powered.
FR68 Series is charging.
Charging complete.
Note: When the battery is initially inserted in the
FR68 Series, the amber LED flashes once if the
battery power is low or the battery is not fully
inserted.
Battery over-temperature condition
Charging error, e.g.:
•
Temperature is too low or too high.
•
Charging has gone on too long without
completion (typically eight hours).
Battery depleted
All those radio devices which are powered on are
available for receiving / sending data.
Any one of the radio devices which is powered on
and not available for receiving / sending data.
All radio off
Data Capture on Page 43.
Chapter 6, Using the Phone.
36
Using the FR68 Series
For information about