Philips PLFRESNEL1 Operation Manual

PLFRESNEL1
THANK YOU FOR PURCHASING A PHILIPS SELECON PLFRESNEL1 LED
LUMINAIRE. WE HAVE DESIGNED THIS LUMINAIRE TO PROVIDE YOU WITH A
SUPERIOR FITTING IN PERFORMANCE, DESIGN AND ENGINEERING. WE ARE
CONFIDENT THAT IT WILL PERFORM TO YOUR EXPECTATIONS FOR MANY
YEARS TO COME.
Caution!
Installation is entirely at your risk. Do not attempt installation unless you are suitably qualified. If you do
not understand a point in this manual, don't guess. Don't take short cuts. If in doubt, stop! Contact Philips Selecon
or one of its authorised distributors for advice. Don't be afraid to ask for help.
This SHORT FORM MANUAL is designed to provide you with the information that you will need IMMEDIATELY upon
unpacking your new luminaire. This manual covers information required for the PLFR1-03 products.
We recommend making a note of the serial numbers of your purchased luminaires for future reference.
(The serial number can be found on the sticker on the side of the yoke on the unit and on the outside of the box the unit was packed in).
Important Note: Before discarding the packaging ensure you have the suspension bolt set
Electrical Installation
WARNING!!! Risk of fire and electric shock. This product is to be installed by a qualified electrician only. Ensure that the AC
power is switched off before attempting to make any wiring connections.
This fixture employs a grounded type receptacle and is not intended for connection to a two-wire, ungrounded source of supply.
To avoid the chance of product damage or malfunction, disconnect power before connecting wires, and do not connect or
disconnect cables (supply, data, lamps and interface cables) when voltage is supplied to the luminaire.
Mains Voltage: 100-240VAC (+/- 10%). unit must be direct switching mains only, not via a dimmer system.
When installing this fixture use wire conductor colour codes as follows:
Mounting
A safety bond MUST always be used when rigging luminaires on bars, trusses, etc. The safety bond is fixed to the luminaire
lamp-house anchor point, located at the rear of the luminaire, and is wrapped around the bar and attached to itself. This is the
only recommended anchor point for the luminaire. Philips Selecon supplies a fitted safety bond with all theatrical / entertainment
luminaires.
Yoke Adjustment
Loosen the fasteners on either side of the yoke,
reposition yoke, tighten fasteners. Ensure yoke is
aligned correctly before tightening fasteners again.
Ambient Operating Temperature:
To guarantee product lifetime, the user should ensure that the ambient temperature remains within the recommended
temperature range.
Philips Selecon has packaged this product using environmentally friendly packaging. Please consider
either reuse of the packaging or dispose of responsibly with your nearest recycling collection agency.
SF PLFresnel1 – December 2012
SHORT FORM OPERATION MANUAL
LED LUMINAIRE
Brown - Phase, live
Blue - Neutral, return
Green/Yellow - Earth, ground
Adjusting the tilt angle
Loosen the lock off handle on the side of the
luminaire, tilt and retighten finger tight
0°C to 40°C
pg1 of 4
Focus
Loosen the focus knob on the bottom of the fixture,
gently slide engine forward for flood and backwards
for spot, tighten focus knob once focused.