It is not allowed to draw the CX400 S1server enclosure partially out
of the rack.
"Removing the server node from the server enclosure" on page 48
Ê
Ê Remove all HDD/SSD modules as described in section
HDD/SSD modules" on page
"Opening the server enclosure" on page 51
Ê
"Removing the power supply module" on page 84
Ê
Ê Remove both fan modules as described in section
module" on page
"Removing the power distribution module" on page 54
Ê
"Removing the midplane" on page 153
Ê
Ê Remove all linking boards as described in section
board" on page 161
7.4.1.3
Removing the 2.5-inch HDD SAS/SATA backplane
Figure 75: Removing the front panel cable from the cable clamps
Ê Remove both front panel cables from the cable clamps.
CX400 S1
106.
137.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Removing the fan
"Removing the linking
"Removing 2.5-inch
121