Overview - HP LH 3r Installation Manual

2 Overview

The steps required to install the NetServer in the rack are summarized below:
NOTE This is only a summary; detailed instructions are provided on the
following pages.
Measure and mark the appropriate holes on all four rack columns
Install one bar nut on each of the four rack columns
Insert two rack nuts on each of the two front columns only
Attach the slides to the columns
Extend the slides
Remove power supply modules and hot-swap drives from the NetServer
Lift the NetServer onto the slides
Secure the NetServer to the slides
Remove the lifting handles from the NetServer
Install the power supply modules and hot-swap drives in the NetServer
Push the NetServer back into the chassis
Install the recessed mounting brackets on the two front columns only
5