AEG BS9304001 User Manual page 15

4. Set the temperature. Press OK to confirm.
Press to go directly to the Heating Functions menu. You can also use it when the appli-
ance is deactivated.
Steam cooking
The water drawer cover is in the control panel.
1. Fill the water drawer with 800 ml of water.
The water supply is sufficient for approximately 50 minutes.
CAUTION!
Do not put water directly in the steam generator!
Use only water as the liquid. Do not use filtered (demineralised) or distilled water.
2. Activate the appliance.
3. Set the steam heating function and temperature.
4. If necessary, set the function Duration
The first steam shows after approximately 2 minutes. When the appliance reaches set
temperature an acoustic signal sounds.
The signal sounds again at the end of the cooking time or when water finishes.
5. Deactivate the appliance.
When the water drawer has been emptied, an acoustic signal sounds.
When the appliance has cooled down, soak up all remaining water from the steam genera-
tor with the Sponge. If necessary, clean the steam generator with some vinegar.
Let the appliance dry fully with the door open.
Heat-up indicator
When you activate an heating function, the bar on the display comes on. The bar shows
that the temperature increases.
Fast Heat Up indicator
This function decreases the heat-up time. To activate the function hold
You will see the heat-up indicator alternates.
Residual heat indicator
When you deactivate the appliance, the display shows the residual heat. You can use the
heat to keep the food warm.
or End Time .
15
Daily use
for 3 seconds.