Front I/O Assembly - HP 100B SFF Maintenance & Service Manual

Front I/O Assembly

The front I/O assembly is attached to the front of the chassis. Pull the assembly away from the chassis
to remove it.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the front audio and front USB cables from the yellow and white system board
connectors.
5. Remove the cables from the clips on the base of the computer chassis, see Fig. 6-11 for details.
Figure 5-11
6. Remove the screw that secures the assembly to the front of the chassis (1).
7. Slide the assembly up and pull it away from the front of the chassis while threading the wires
through the hole in the chassis (2).
Figure 5-12
To install the front I/O assembly, reverse the removal procedure.
NOTE: Be sure to correctly route the cables when reinstalling the assembly. Proper cable routing
prevents damage to the cables and promotes proper air flow.
34
(Access Panel on page
(Front Bezel on page
Front I/O assembly cable clip locations
Removing the front I/O assembly
(Preparation for Disassembly on page
23).
24).
22).