Adjustments; Functional Alignment (1) - Sony SDM-S51 Service Manual

2-1. FUNCTIONAL ALIGNMENT (1)

•Procedures of how to go to service mode.
1. Hold "C" and "B" key power on, SDM-S51 goes into service mode.
2. Press "MENU" key-----ODS display
3. Press "-" key to go to second page's late icon.
4. Press "OK" key-----service menu display.
5. Select one of features.
6. Press "MENU" key to exit OSD.
7. Power OFF then ON again, monitor go to normal mode.
If you would like to enter service mode again, performing the above procedures cycle.
Note
1. N/A means "Not applied".
2. This service menu only provides both Configuration & Sync slice functions.
This other were used for design engineering.
contigulation RGB Reset
OK
CONFIGUR ATION
(N/A)
CHIPS
SYNC SLICE
EXIT
There is no guarantee of using those N/A functions.

ADJUSTMENTS

contigulation
2 COLO R TEMP
INITIAL EE PROM
CLEAR ETI TIME
1 RGB RESET
(N/A) EEPROM TEST
EXIT
PERFORM
On
Off
Color Temp.
ANALOG
9300K
6500K
5000K
EXIT
INITIAL EE PRM
SUB-BRIGHTNESS
R
G
B
SUB-CONTRAST
R
G
B
EXIT