Configuration
Time-Lapse Record Mode Setup Screen
Access the Time-Lapse Record Setup screen (MENU
Record) and then press # . The Time-Lapse Record Setup screen displays.
1.
2.
3.
Rev 3.01
Figure 3-28
Highlight the box under the Speed heading and then press # . A drop-down list of
record speeds displays. You can select from 1 image per 10 seconds to 60
images per second for NTSC (to 50 images per second for PAL).
Note
If you set the Record Resolution to High, you will not be able to
select 60 ips NTSC (50 ips PAL).
Highlight the box under the Quality heading and then press # . A drop-down list
displays. You can select from Very High, High, Standard, and Low image quality.
All other variables being equal, Very High will require 600% more hard disk space
than Standard, High will require 250% more, and Low 30% less.
Note
Higher quality images require more storage space and reduce
the recording capacity of the hard disk drive.
You can set the maximum amount of time-lapse video to be stored. After the DVR
reaches this amount, it will start recording over the oldest time-lapse video. The
time-lapse video is stored separate from Event video. When Keep the continuous
pictures is set to On, you can set the time from 1 Hour to the maximum allowed
by the storage capacity of your hard disk drive.
Time-Lapse Record Setup Screen
47
Record
Time-Lapse
Document 900.0258
10/05