Removing The Cutting Unit - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions

Removing the cutting unit

Rider Pro 15
1
• Apply the parking brake.
• Adjust the cutting height to its lowest setting.
• Remove the front cover.
2
Release the two support wheels under the front
cover.
3
Fit the two support wheels on each side of the
lower part of the deck.
WARNING!
Wear protective glasses when
removing the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
50
– Svenska
www.mymowerparts.com
3
Release the spring for the drive belt's tensioning
wheel. Move the cutting height lever to the lower
position.
4
Place one foot on the front edge of the deck by the
wheel, and lift the front edge of the deck to simplify
releasing the height setting rod. Secure the rod in
the holder.